FRONT PASSENGER AIRBAG ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (When Installed in Vehicle) |
![]() |
Check the function of SST.
![]() |
Connect the red clip of SST to the positive battery terminal and the black clip of SST to the negative battery terminal.
| *1 | Battery |
Press the SST activation switch, and check that the LED on the SST activation switch illuminates.
Disconnect SST from the battery.
Disconnect the cable from the negative (-) battery terminal.
Remove the instrument cluster finish panel garnish assembly .
Install SST to the instrument panel wire inflator side.
![]() |
Pull the slider in the direction indicated by the arrow to release the lock and disconnect the airbag connector.
| *1 | Slider |
Connect SST connector to the instrument panel wire inflator side.
Check that the lock slider is in the lock position.
![]() |
Connect SST connector.
Close all doors.
![]() |
Move SST at least 10 m (33 ft.) away from the vehicle front side window.
| *1 | Battery |
Deploy the instrument panel passenger airbag assembly inflator.
Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
Press SST activation switch and deploy the airbag.
| 2. DISPOSE OF INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (When not Installed in Vehicle) |
![]() |
Check the function of SST.
![]() |
Connect the red clip of SST to the positive battery terminal and the black clip of SST to the negative battery terminal.
| *1 | Battery |
Press the SST activation switch, and check that the LED on the SST activation switch illuminates.
Disconnect SST from the battery.
Remove the instrument panel passenger airbag assembly (Click here).
Connect SST.
![]() |
Connect SST connector.
![]() |
Push in the locking button.
| *1 | Locking Button |
![]() |
Using a braided wire harness, tie the instrument panel passenger airbag assembly to a tire.
| *a | Stripped Wire Harness Section |
| Area | Measurement |
| A | 1.25 mm2 or more (0.00192 in.2 or more) |
Position the instrument panel passenger airbag assembly inside a tire with the airbag deployment side facing inside.

| Area | Measurement |
| A | 360 mm (14.17 in.) |
| B | 185 mm (7.28 in.) |
![]() |
Place tires.
| *1 | Tires (2 or more) |
Place at least 2 tires under the tire which the instrument panel passenger airbag assembly is tied to.
Place at least 2 tires over the tire which the instrument panel passenger airbag assembly is tied to. The top tire should have a disc wheel installed.
![]() |
Tie the tires together with 2 wire harnesses.
Install SST.
![]() |
Connect SST connector.
| *1 | Battery |
Deploy the instrument panel passenger airbag assembly inflator.
Connect the red clip of SST to the positive battery terminal and the black clip of SST to the negative battery terminal.
Check that no one is within a 10 m (33 ft.) radius of the tire which the instrument panel passenger airbag assembly is tied to.
Press SST activation switch and deploy the airbag.
Disconnect the red clip of SST from the positive (+) battery terminal and the black clip of SST from the negative (-) battery terminal.
![]() |
Dispose of the lower instrument panel passenger airbag assembly.
| *1 | Plastic Bag |
Remove the lower instrument panel passenger airbag assembly from the tire.
Place the lower instrument panel passenger airbag assembly in a plastic bag, tie it tightly and dispose of it according to local regulations.