Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD

STEERING PAD > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL STEERING PAD
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B282592E01
  1. Connect the airbag connector.
    Text in Illustration 
    *1
    Locking Button

  1. Push in the locking button.

    NOTICE:
    1. Do not damage the airbag wire harness when connecting the airbag connector.
    2. Securely lock the locking button.

  1. Connect the horn terminal.



    B293017
  1. Engage the 3 pins with the 3 snap rings to install the steering pad.

    NOTICE:
    Pull the steering pad to ensure that it is securely engaged.



2. INSTALL LOWER NO. 2 STEERING WHEEL COVER
  1. Engage the 2 claws to install the lower No. 2 steering wheel cover.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSPECT SRS WARNING LIGHT
(Click here)