Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD

STEERING PAD > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE LOWER NO. 2 STEERING WHEEL COVER


B282589E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the lower No. 2 steering wheel cover.
    Text in Illustration 
    *1
    Protective Tape



4. REMOVE STEERING PAD


B282590
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Using a "TORX" driver, push in the 3 snap rings to disengage it from the 3 pins.

    NOTICE:
    Lightly hold the steering pad to prevent it from falling.

  1. Pull the steering pad toward rear.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver with its tip wrapped with protective tape, release the locking button.



    B282591E01
  1. Disconnect the airbag connector.

    NOTICE:
    When disconnecting the airbag connector, take care not to damage the airbag wire harness.

    Text in Illustration 
    *1
    Protective Tape
    *2
    Locking button

  1. Disconnect the horn terminal.