SPIRAL CABLE > INSTALLATION |
| 1. INSTALL SPIRAL CABLE SUB-ASSEMBLY (w/o VSC) |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Check that the front tires face straight forward.
Check that the turn signal switch is in the neutral position.
Engage the 3 claws to install the spiral cable sub-assembly.
Connect the airbag connector.
Connect the horn connector.
| 2. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (w/ VSC) |
Check that the ignition switch is turned off.
Check that the negative battery terminal is detached.
Check that the front tires face straight forward.
Check that the turn signal switch is in the neutral position.
Engage the 3 claws to install the spiral cable with sensor sub-assembly.
Connect the steering sensor connector.
Connect the airbag connector.
Connect the horn connector.
| 3. INSTALL UPPER STEERING COLUMN COVER |
Engage the claw to install the upper steering column cover.
| 4. INSTALL LOWER STEERING COLUMN COVER |
Engage the 4 claws to install the lower steering column cover.
Install the 3 screws.
| 5. ADJUST SPIRAL CABLE |
Check that the ignition switch is turned off.
Check that the cable is disconnected from the negative (-) battery terminal.
Confirm that the front tires face straight forward.
Center the spiral cable.
![]() |
Turn the spiral cable counterclockwise until it locks.
![]() |
Turn the spiral cable 2.5 times clockwise from its locked position and align the alignment marks.
| *a | Alignment Mark |
| 6. INSTALL STEERING WHEEL ASSEMBLY |
Align the matchmarks and install the steering wheel assembly onto the steering column assembly.
Install the nut.
Connect all the connectors to the spiral cable.
| 7. INSTALL STEERING PAD |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Connect the airbag connector.
| *1 | Locking Button |
Push in the locking button.
Connect the horn terminal.
![]() |
Engage the 3 pins with the 3 snap rings to install the steering pad.
| 8. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
Engage the 2 claws to install the lower No. 2 steering wheel cover.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. INSPECT SRS WARNING LIGHT |