Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL NO. 2 INSTRUMENT PANEL WIRE


B282644E01
  1. Connect the airbag connector to the No. 2 instrument panel wire.
    Text in Illustration 
    *1
    Locking Button

  1. Push in the locking button.

    NOTICE:
    1. Do not damage the airbag wire harness when connecting the airbag connector.
    2. Securely lock the locking button.



2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B285685E01
  1. Engage the 3 hooks B.

  1. Engage the 3 hooks A to install the instrument panel passenger airbag assembly.



    B282641
  1. Install the 2 screws

  1. Engage the 2 clamps.



3. INSTALL NO. 2 HEATER TO REGISTER DUCT


    B284251
  1. Engage the 4 guides and install the heater to register duct with the 4 <A> screws.



4. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSPECT SRS WARNING LIGHT
(Click here)