AUTOMATIC TRANSAXLE SYSTEM > CHECK MODE PROCEDURE |
| DESCRIPTION |
Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1 trip detection logic.
| CHECK MODE PROCEDURE |
Procedure for check mode using the intelligent tester.
Check the initial conditions.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
![]() |
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode (Check that the MIL flashes as shown in the illustration).
Start the engine (the MIL goes off after the engine starts).
Perform Monitor Drive Pattern for the ECT test (Click here), or simulate the conditions of the malfunction described by the customer.
After simulating malfunction conditions, use the intelligent tester to check the DTCs and freeze frame data.