DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0711 | Either of following Condition (A) or (B) is met: |
|
| Condition (A): All of (a) and (b) are detected. (2 trip detection logic) (a) Intake air and engine coolant temperatures are -10°C (14°F) or more at engine start. (b) After normal driving for over 19 minutes and 7 km (4.4 miles) or more, ATF temperature is less than 10°C (50°F). | ||
| Condition (B): Both (a) and (b) are detected. (2 trip detection logic) (a) Engine coolant temperature is less than 35°C (95°F) at engine start. (b) ATF temperature is 100°C (212°F) or more when engine coolant temperature reaches 60°C (140°F). |
| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data.
In accordance with the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | ATF Temperature Sensor Value/ min.: -40°C (-40°F) max.: 215°C (419°F) |
| If value is -40°C (-40°F) or 150°C (302°F) or more, ATF temperature sensor circuit is open or short. |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
| Only DTC P0711 is output | A |
| P0711 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
Check the transmission fluid level (Click here).
|
| ||||
| OK | ||
| ||