Home › Engine / Hybrid System · 2NZ-FE › STARTING › IGNITION SWITCH

IGNITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    A247262E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      Between all terminals
      LOCK
      10 kΩ or higher
      2 (ACC) - 4 (AM1)
      ACC
      Below 1 Ω
      1 (IG1) - 2 (ACC) - 4 (AM1)
      ON
      Below 1 Ω
      5 (AM2) - 6 (IG2)
      1 (IG1) - 4 (AM1)
      START
      Below 1 Ω
      5 (AM2) - 6 (IG2) - 7 (ST2)

      If the result is not as specified, replace the ignition or starter switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Ignition or Starter Switch Assembly)
      *b
      LOCK
      *c
      ACC
      *d
      ON
      *e
      START