Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Built-in Type Yaw Rate Sensor)

VEHICLE STABILITY CONTROL SYSTEM (for Built-in Type Yaw Rate Sensor) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the vehicle stability control system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the trouble (Click here).


    NEXT


    3.CHECK DTC AND FREEZE FRAME DATA*
    1. Check and record DTC and Freeze Frame Data.

    2. Clear the DTC and Freeze Frame Data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

    3. Reconfirm the DTC.

      1. Reconfirm the DTC based on the recorded DTC and Freeze Frame Data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).

        HINT:
        If any of the DTCs U0100, U0123, U0124, U0126, and U0142 are output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (Click here).

    4. Result 
      Result
      Proceed to
      DTC is output
      A
      DTC is not output (Problem symptom does not occur)
      B
      DTC is not output (Problem symptom occurs)
      C


    B.
    GO TO STEP 5

    C.
    GO TO STEP 6
    A


    4.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).


    NEXT

    GO TO STEP 7


    5.SYMPTOM SIMULATION
    1. Proceed to Check for Intermittent Problems (Click here).


    NEXT


    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).


    NEXT


    7.CIRCUIT INSPECTION*

      NEXT


      8.IDENTIFICATION OF PROBLEM

        NEXT


        9.REPAIR OR REPLACE

          NEXT


          10.CONFIRMATION TEST*

            NEXT

            END