Component
| Function
|
Speed sensor
| Detects the wheel speed and sends the signal to the skid control ECU (brake actuator assembly).
|
Stop light switch
| Detects the brake operating conditions and inputs the results to the skid control ECU (brake actuator assembly).
|
Main body ECU (Multiplex Network Body ECU)
| Detects the parking brake operating conditions and inputs the results to the skid control ECU (brake actuator assembly) via CAN communication.
|
Skid control ECU
| - Housed in the brake actuator assembly.
- Processes the signals sent from each sensor to control the ABS and EBD
|
Brake actuator assembly
| - Consists of the master cylinder cut solenoid valve, retention solenoid valve, pressure reduction solenoid valve, pump motor, and reservoir, and adjusts the brake fluid pressure applied to each wheel cylinder.
- Houses the skid control ECU.
|
Motor relay
| - Supplies power to the pump motor.
- Housed in the brake actuator assembly.
|
Solenoid relay
| - Supplies power to each solenoid.
- Housed in the brake actuator assembly.
|
ABS warning light
| - Comes on to inform the driver that a malfunction in the ABS and/or BA has occurred.
- Blinks to output DTC.
|
Brake warning light
| - Comes on to inform the driver that the parking brake is ON when the system is normal, or that the brake fluid has decreased.
- Comes on to inform the driver that a malfunction in the EBD has occurred.
|
ECM
| Controls the engine information and inputs the results to the skid control ECU via CAN communication.
|