ANTI-LOCK BRAKE SYSTEM > CHECK FOR INTERMITTENT PROBLEMS |
| CHECK FOR INTERMITTENT PROBLEMS |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Follow the directions on the intelligent tester to display the Data List and select areas where momentary interruptions should be monitored.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Speed Open | FR speed sensor open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| FL Speed Open | FL speed sensor open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| RR Speed Open | RR speed sensor open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| RL Speed Open | RL speed sensor open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| EFI Communication Open | EFI communication open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| IG Voltage Value Decreased | IG voltage value decrease detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| IG Voltage Value Increased | IG voltage value increase detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| FR Speed Sensor Voltage Open | Front speed sensor RH voltage open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| FL Speed Sensor Voltage Open | Front speed sensor LH voltage open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| RR Speed Sensor Voltage Open | Rear speed sensor RH voltage open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| RL Speed Sensor Voltage Open | Rear speed sensor LH voltage open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
| Body ECU Communication Open | Status of the Body ECU communication open detection/Normal or Error | Normal: Normal Error: Momentary interruption | - |
While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.