DTC C1425 Open in Stop Light Switch Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1425 | When IG1 terminal voltage is between 9.5 and 17.4 V, an open stop light switch circuit (A to B, A to body ground) continues for 3 seconds or more. |
|

| 1.CHECK STOP LIGHT SWITCH OPERATION |
Check that the stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.
| Condition | Illumination Condition |
| Brake pedal depressed | ON |
| Brake pedal released | OFF |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light SW | Stop light switch / OFF or ON | OFF: Brake pedal released ON: Brake pedal depressed | - |
Check that the stop light condition observed on the intelligent tester changes according to brake pedal operation.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Depress the brake pedal several times to test the stop light circuit.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC C1425 is not output | A |
| DTC C1425 is output | B |
|
| ||||
| A | ||
| ||
| 4.CHECK TERMINAL VOLTAGE (STP TERMINAL) |
![]() |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A54-2 (STP) - Body ground | Stop light switch ON (Brake pedal depressed) | 8 to 14 V |
| Stop light switch OFF (Brake pedal released) | Below 1.5 V |
| *a | Front view of wire harness connector (to Skid control ECU) |
Reconnect the skid control ECU connector.
|
| ||||
| OK | ||
| ||