DTC C1432 Steering Angle Sensor Power Source Voltage Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1432 | Steering angle sensor power supply malfunction signal is received from steering angle sensor. |
|

| 1.CHECK TERMINAL VOLTAGE (BAT TERMINAL) |
![]() |
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the steering angle sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F30-6 (BAT) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | |
| 2.CHECK TERMINAL VOLTAGE (IG TERMINAL) |
![]() |
Remove the steering wheel and the column cover lower.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F30-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ESS TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F30-2 (ESS) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Steering angle sensor) |
Reconnect the steering angle sensor connector.
Reinstall the steering wheel and the column cover lower.
|
| ||||
| OK | ||
| ||