Home › Engine / Hybrid System · 1NZ-FE › FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    A247861E01
  1. Check that the float moves smoothly between F and E.



    A246962E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    F (Upper End)
    12.0 to 18.0 Ω
    1 - 2
    E (Lower End)
    405.0 to 415.0 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sender Gauge Assembly)
    If the result is not as specified, replace the fuel sender gauge assembly.