Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
  1. Pass the hood lock control cable into the engine compartment.



  1. Connect the clamps as shown in the illustration.


    B284572E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Clamp
    *3
    Grommet
    -
    -



2. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
  1. Pass the hood lock control cable into the engine compartment.



  1. Connect the clamps as shown in the illustration.


    B284573E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Clamp
    *3
    Grommet
    -
    -



3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
  1. Connect the hood lock control cable to the hood lock control lever.

  1. Engage the 3 claws and install the hood lock control lever.



4. INSTALL HOOD LOCK ASSEMBLY


    B284544
  1. Apply MP grease to the sliding areas of the hood lock.

  1. Connect the hood lock control cable.

  1. Install the hood lock with the 3 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



5. INSPECT HOOD SUB-ASSEMBLY


  1. Check that the clearance measurements are within the standard ranges.


    B284557E01


    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    2.0 to 6.0 mm
    (0.0787 to 0.236 in.)
    D
    2.3 to 5.3 mm
    (0.0905 to 0.208 in.)
    B
    11.0 mm
    (0.433 in.)
    E
    1.2 to 5.2 mm
    (0.0472 to 0.204 in.)
    C
    5.0 mm
    (0.196 in.)
    -
    -



6. ADJUST HOOD SUB-ASSEMBLY


    B271586
  1. Loosen the 4 hood side hinge bolts.

  1. Move the hood to adjust the clearance to within the standard range (Click here).

  1. Tighten the 4 hood side hinge bolts after the adjustment.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    B284563
  1. Adjust the height of the hood front end by turning the 2 center hood cushions (Click here).

    HINT:
    The center hood cushion can be raised and lowered by turning it.



  1. Adjust the hood lock.



      B273453
    1. Loosen the 3 bolts.

    2. Adjust the hood lock position so that the striker can enter it smoothly (Click here).

    3. Tighten the 3 bolts after the adjustment.

      Torque:
      7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



7. INSTALL FRONT FENDER LINER LH (for LHD)
  1. Install the front fender liner with 7 clips, 2 screws and 4 new grommets.



8. INSTALL FRONT FENDER LINER RH (for RHD)

HINT:
Use the same procedure as for the LH side .