Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FRONT FENDER LINER LH (for LHD)



C234705

  1. Remove the 7 clips, 2 screws and 4 grommets and remove the front fender liner.

    HINT:
    The grommet needs to be replaced with a new one because it will break when it is removed.



2. REMOVE FRONT FENDER LINER RH (for RHD)

HINT:
Use the same procedures for the LH and RH side .



3. REMOVE HOOD LOCK ASSEMBLY


    B271587
  1. Remove the 3 bolts and the hood lock.

  1. Disconnect the hood lock control cable.



4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B284569
  1. Disengage the 3 claws and remove the hood lock control lever.

  1. Disconnect the hood lock control cable.



5. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


  1. Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.


    B284572E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Clamp
    *3
    Grommet
    -
    -

  1. Pull the hood lock control cable from the engine compartment and remove it.



6. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


  1. Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.


    B284573E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Clamp
    *3
    Grommet
    -
    -

  1. Pull the hood lock control cable from the engine compartment and remove it.