1NZ-FE SFI SYSTEM > Fuel Injector Circuit |

| 1.CHECK FUEL INJECTOR ASSEMBLY (POWER SOURCE) |
Disconnect the fuel injector assembly connectors.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| B5-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B7-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B9-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B11-1 - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT FUEL INJECTOR ASSEMBLY (INJECTION AND VOLUME) |
Inspect the fuel injector injection and volume (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (FUEL INJECTOR ASSEMBLY - ECM) |
Disconnect the fuel injector assembly connectors.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B5-2 - B84-108 (#10) | Always | Below 1 Ω |
| B7-2 - B84-107 (#20) | Always | Below 1 Ω |
| B9-2 - B84-106 (#30) | Always | Below 1 Ω |
| B11-2 - B84-105 (#40) | Always | Below 1 Ω |
| B5-2 or B84-108 (#10) - Body ground | Always | 10 kΩ or higher |
| B7-2 or B84-107 (#20) - Body ground | Always | 10 kΩ or higher |
| B9-2 or B84-106 (#30) - Body ground | Always | 10 kΩ or higher |
| B11-2 or B84-105 (#40) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (INTEGRATION NO. 1 RELAY (IG2 RELAY) - FUEL INJECTOR ASSEMBLY) |
Disconnect the fuel injector assembly connectors.
Remove the No. 1 integration relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B5-1 - 1E-2 | Always | Below 1 Ω |
| B7-1 - 1E-2 | Always | Below 1 Ω |
| B9-1 - 1E-2 | Always | Below 1 Ω |
| B11-1 - 1E-2 | Always | Below 1 Ω |
| B5-1 or 1E-2 - Body ground | Always | 10 kΩ or higher |
| B7-1 or 1E-2 - Body ground | Always | 10 kΩ or higher |
| B9-1 or 1E-2 - Body ground | Always | 10 kΩ or higher |
| B11-1 or 1E-2 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||