Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time

NOTICE:
In the table below, the values listed under Normal Condition are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3

  3. Turn the ignition switch to ON.

  4. Turn the intelligent tester on.

  5. Enter the following menus: Body / Main Body / Data List.

  6. According to the display on the intelligent tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch / OFF or ON
    OFF: Ignition key is not inserted
    ON: Ignition key is inserted
    -
    ACC SW
    Ignition switch ACC signal / OFF or ON
    OFF: Ignition switch off
    ON: Ignition switch ACC
    -
    IG SW
    Ignition switch ON signal / OFF or ON
    OFF: Ignition switch off
    ON: Ignition switch ON
    -
    FL Door Courtesy
    Front LH door courtesy light switch signal / ON or OFF
    ON: Front LH door closed
    OFF: Front LH door opened
    -