Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / (desired system) / Data List.

  5. According to the display on the intelligent tester, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    P-Seatbelt Buckle SW
    Front passenger side seat belt buckle signal / OFF or ON
    OFF: Front passenger side seat belt unfastened
    ON: Front passenger side seat belt fastened
    -
    Driver Side Seatbelt Warning Buzzer
    Driver side seat belt warning buzzer signal / OFF or ON
    OFF: Seat belt warning buzzer disabled
    ON: Seat belt warning buzzer enabled
    The current customize setting is displayed.
    P - Seatbelt Warning Buzzer
    Front passenger side seat belt warning buzzer signal / OFF or ON
    OFF: Seat belt warning buzzer disabled
    ON: Seat belt warning buzzer enabled
    The current customize setting is displayed.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Seat Buckle SW
    Driver side seat belt buckle signal / OFF or ON
    OFF: Driver side seat belt unfastened
    ON: Driver side seat belt fastened
    -
    FR Door Courtesy
    Front door courtesy light switch RH signal / ON or OFF
    ON: Front door RH closed
    OFF: Front door RH opened
    -
    FL Door Courtesy
    Front door courtesy light switch LH signal / ON or OFF
    ON: Front door LH closed
    OFF: Front door LH opened
    -


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Combination Meter / Active Test.

  5. According to display on the intelligent tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Driver Side Seat Belt
    Driver side seat belt warning light
    OFF/ON
    Confirm that the vehicle is stopped and the engine is idling.