Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SPEEDOMETER
  1. Check speedometer operation.

    NOTICE:
    1. The meter ECU receives the vehicle speed signal from the skid control ECU via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU because it is the source of the vehicle speed signal.
    2. The Data List values of the skid control ECU are used for this inspection. Therefore, make sure to perform the inspection after confirming that no DTCs are output from the brake control system.
    3. If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform the inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.


    1. Before starting the following inspection, check if the Brake Control System outputs the DTCs.

    2. Check the values by referring to the table below.

      ABS/VSC/TRC 
      Tester Display
      Measurement Item/Range
      Normal Condition
      Diagnostic Note
      Vehicle Speed
      Maximum wheel speed sensor reading/
      Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
      Vehicle stopped: 0 km/h (0 mph)
      When driving at constant speed: No large fluctuations

      Reference (km/h) (except Australia) 
      Intelligent Tester Indication (km/h)
      Acceptable Range (km/h)
      20
      21 to 25
      40
      41.7 to 46.2
      60
      62.7 to 67.2
      80
      83.4 to 88.4
      100
      104.3 to 109.3
      120
      125.1 to 130.6
      140
      145.8 to 151.8
      160
      166.2 to 173.2
      180
      186.9 to 194.5
      200
      207.7 to 215.7

      Reference (km/h) (for Australia) 
      Intelligent Tester Indication (km/h)
      Acceptable Range (km/h)
      20
      20.7 to 24.7
      40
      41.4 to 45.4
      60
      62.1 to 66.1
      80
      82.8 to 86.8
      100
      103.5 to 108.0
      120
      124.2 to 129.2
      140
      144.9 to 149.9
      160
      165.7 to 170.7
      180
      186.4 to 191.4
      200
      207.1 to 212.1



2. INSPECT TACHOMETER
  1. Check the operation.

    1. Connect the intelligent tester, and start the engine.

    2. Compare the test results with the tachometer indications.

      Reference 
      Intelligent Tester Indication (rpm)
      Acceptable Range (rpm)
      Data in ( ) is for Reference
      700
      630 to 770
      1000
      (900 to 1100)
      2000
      (1850 to 2150)
      3000
      2800 to 3200
      4000
      (3800 to 4200)
      5000
      4800 to 5200
      6000
      (5750 to 6250)