Home › Engine / Hybrid System · 1NZ-FE › STARTING › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STARTER RELAY


E209082
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage not applied
      10 kΩ or higher
      3 - 5
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      1. If the result is not as specified, replace the relay.