Home › Drivetrain ยท U441E AUTOMATIC TRANSMISSION / TRANSAXLE › SPEED SENSOR (w/o ABS)

SPEED SENSOR (w/o ABS) > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION REVOLUTION SENSOR
  1. Coat a new O-ring with Toyota Genuine ATF Type T-IV and install it to the transmission revolution sensor.

  1. Install the transmission revolution sensor to the automatic transaxle assembly with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission revolution sensor connector.



2. INSTALL SPEEDOMETER SENSOR
  1. Coat a new O-ring with Toyota Genuine ATF Type T-IV and install it to the speedometer sensor.

  1. Install the speedometer driven gear to the speedometer sensor with the E-ring.

  1. Install the speedometer sensor to the automatic transaxle assembly with the bolt.

    Torque:
    11 N*m{ 115 kgf*cm , 8 in.*lbf }

  1. Connect the speedometer sensor connector.



3. INSTALL BATTERY CARRIER (for LHD)
  1. Install the battery carrier with the 5 bolts.

    Torque:
    17 N*m{ 173 kgf*cm , 13 ft.*lbf }

  1. Engage the 6 wire harness clamps and install the wire harness.



4. INSTALL BATTERY CARRIER (for RHD)
  1. Install the battery carrier with the 5 bolts.

    Torque:
    17 N*m{ 173 kgf*cm , 13 ft.*lbf }

  1. Engage the 7 wire harness clamps and install the wire harness.



5. INSTALL BATTERY TRAY


6. INSTALL BATTERY
  1. Install the battery onto the vehicle with the battery clamp.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }

  1. Connect the cable to the battery terminal.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



7. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK