Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SPEED SENSOR

SPEED SENSOR > REMOVAL

for Preparation Click here



1. REMOVE BATTERY


A248909
  1. Disconnect the cable from the battery terminal.

  1. Loosen the 2 nuts and remove the battery clamp.

  1. Remove the battery.



2. REMOVE BATTERY TRAY


3. REMOVE BATTERY CARRIER (for LHD)


A259809
  1. Disengage the 6 wire harness clamps and separate the wire harness from the battery carrier.

  1. Remove the 5 bolts and the battery carrier.



4. REMOVE BATTERY CARRIER (for RHD)


A247997
  1. Disengage the 7 wire harness clamps and separate the wire harness from the battery carrier.

  1. Remove the 5 bolts and the battery carrier.



5. REMOVE TRANSMISSION REVOLUTION SENSOR


    C117098
  1. Disconnect the transmission revolution sensor connector.

  1. Remove the bolt and the transmission revolution sensor from the automatic transaxle assembly.



    C117099E01
  1. Remove the O-ring from the transmission revolution sensor.
    Text in Illustration 
    *1
    O-ring