Home › Drivetrain ยท U441E AUTOMATIC TRANSMISSION / TRANSAXLE › SPEED SENSOR (w/o ABS)

SPEED SENSOR (w/o ABS) > REMOVAL

for Preparation Click here



1. REMOVE BATTERY


A248909
  1. Disconnect the cable from the battery terminal.

  1. Loosen the 2 nuts and remove the battery clamp.

  1. Remove the battery.



2. REMOVE BATTERY TRAY


3. REMOVE BATTERY CARRIER (for LHD)


A259809
  1. Disengage the 6 wire harness clamps and separate the wire harness from the battery carrier.

  1. Remove the 5 bolts and the battery carrier.



4. REMOVE BATTERY CARRIER (for RHD)


A247997
  1. Disengage the 7 wire harness clamps and separate the wire harness from the battery carrier.

  1. Remove the 5 bolts and the battery carrier.



5. REMOVE TRANSMISSION REVOLUTION SENSOR


    C107787E01
  1. Disconnect the transmission revolution sensor connector.

  1. Remove the bolt and the transmission revolution sensor from the automatic transaxle assembly.



    C117099E01
  1. Remove the O-ring from the transmission revolution sensor.
    Text in Illustration 
    *1
    O-ring



6. REMOVE SPEEDOMETER SENSOR


    C186726E01
  1. Disconnect the speedometer sensor connector.

  1. Remove the bolt and the speedometer sensor from the automatic transaxle assembly.



    C117097E05
  1. Remove the E-ring and the speedometer driven gear from the speedometer sensor.
    Text in Illustration 
    *1
    Speedometer Driven Gear
    *2
    O-ring
    *3
    E-ring

  1. Remove the O-ring from the speedometer sensor.