Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER LH (for Plastic Type)


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)


3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


C117100
  1. Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

  1. Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.



4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Disconnect the connector from the park/neutral position switch assembly.



    C117101
  1. Remove the nut, washer and the control shaft lever.



    C117104
  1. Pry out the lock plate and remove the nut, lock plate and washer.



    C117106
  1. Remove the 2 bolts and pull out the park/neutral position switch assembly from the automatic transaxle assembly.