Home › Drivetrain · U441E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION WIRE


    C117650E83
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Transmission Wire)

    Standard Resistance:
    Tester Connection
    Oil Temperature
    Specified Condition
    1 (OT+) - 6 (OT-)
    10°C (50°F)
    6.4 kΩ
    1 (OT+) - 6 (OT-)
    110°C (230°F)
    0.2 kΩ

    If the resistance is not as specified, replace the transmission wire.