Home › Drivetrain ยท U441E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY
  1. Coat a new No. 1 governor apply gasket with Toyota Genuine ATF Type T-IV, and install it to the transaxle case.

  1. Connect the manual valve control rod to the manual valve lever.



    C203895E01
  1. Temporarily install the transmission valve body assembly with the 14 bolts.
    Bolt Length 
    Bolt
    Bolt Length
    A
    20 mm (0.787 in.)
    B
    28 mm (1.102 in.)
    C
    49 mm (1.929 in.)
    D
    36 mm (1.417 in.)
    E
    40 mm (1.575 in.)

  1. Tighten the 14 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }



2. INSTALL TRANSMISSION WIRE
  1. Engage the clamp and instal the transmission wire.

  1. Connect the 5 connectors to the transmission valve body assembly.



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
  1. Coat a new oil strainer gasket with Toyota Genuine ATF Type T-IV and install it to the valve body oil strainer assembly.

  1. Install the valve body oil strainer assembly with the 3 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
  1. Install the 2 oil cleaner magnets to the automatic transaxle oil pan sub-assembly.

  1. Install the automatic transaxle oil pan sub-assembly and a new automatic transaxle oil pan gasket with the 18 bolts.

    Torque:
    7.0 N*m{ 70 kgf*cm , 61 in.*lbf }



5. ADD AUTOMATIC TRANSAXLE FLUID

Automatic Transaxle Fluid:
Classification
Capacity
Toyota Genuine ATF T-IV
Dry fill
5.6 liters (5.9 US qts, 4.9 Imp. qts)
Drain and refill
2.5 liters (2.6 US qts, 2.2 Imp. qts)



6. INSPECT AUTOMATIC TRANSAXLE FLUID


D025120E13

HINT:
Drive the vehicle until the engine and transaxle are at normal operating temperature.

Fluid temperature:
70 to 80 °C (158 to 176 °F)

Text in Illustration 
*a
OK if hot
*b
Add if hot
  1. Park the vehicle on a level surface and engage the parking brake.

  1. With the engine idling and the brake pedal depressed, shift the shift lever into all positions from P to L, and then return it to P.

  1. Pull out the oil level dipstick and wipe it clean.

  1. Push it fully back into the pipe.

  1. Pull it out and check that the fluid level is within the HOT range.
    If there is any leakage, repair or replace O-rings, seal packing, oil seals, plugs or other parts.



7. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK


8. INSTALL ENGINE UNDER COVER LH (for Plastic Type)


9. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)