Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER LH (for Plastic Type)


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)


3. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


C062684E10
  1. Remove the 19 bolts, automatic transaxle oil pan sub-assembly and the automatic transaxle oil pan gasket.

    NOTICE:
    Some fluid will remain in the automatic transaxle oil pan sub-assembly. Remove all the oil pan bolts, and carefully remove the automatic transaxle oil pan sub-assembly.



    C093943E16
  1. Remove the 2 oil cleaner magnets from the automatic transaxle oil pan sub-assembly.



    AT00103E01
  1. Examine the particles in the automatic transaxle oil pan sub-assembly.

    1. Collect any steel chips using the removed oil cleaner magnets.
      Carefully inspect the foreign matter and particles in the automatic transaxle oil pan sub-assembly and on the oil cleaner magnets to guess at the type of wear which might be found in the automatic transaxle.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bearing wear



5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


C062685E02
  1. Remove the 3 bolts and the valve body oil strainer assembly.

    NOTICE:
    Perform the operation carefully as some fluid will come out from the valve body oil strainer assembly.



    D005904E12
  1. Remove the oil strainer gasket from the valve body oil strainer assembly.



6. SEPARATE TRANSMISSION WIRE


    C093938E05
  1. Disconnect the 5 connectors from the transmission valve body assembly.

  1. Remove the bolt and the lock plate, and separate the transmission wire.



7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    C093939E37
  1. Remove the 2 bolts, manual detent spring cover and the manual detent spring.
    Text in Illustration 
    *1
    Manual Detent Spring
    *2
    Manual Detent Spring Cover



    C093940E10
  1. Remove the 13 bolts and the transmission valve body assembly.

    NOTICE:
    Do not drop the check ball body, check ball body spring or accumulator piston.



    D005901E07
  1. Remove the check ball body and the check ball body spring.
    Text in Illustration 
    *1
    Check Ball Body
    *2
    Check Ball Body Spring



    D005902E01
  1. Remove the transaxle case 2nd brake gasket and the transaxle case gasket.