Home › Drivetrain ยท U441E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER LH (for Plastic Type)


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)


3. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    17 N*m{ 175 kgf*cm , 13 ft.*lbf }



4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


C203891
  1. Remove the 18 bolts, automatic transaxle oil pan sub-assembly and the automatic transaxle oil pan gasket.

    NOTICE:
    Some fluid will remain in the automatic transaxle oil pan sub-assembly. Remove all the oil pan bolts, and carefully remove the automatic transaxle oil pan sub-assembly.



    C057519E01
  1. Remove the 2 oil cleaner magnets from the automatic transaxle oil pan sub-assembly.



    AT00103E01
  1. Examine the particles in the automatic transaxle oil pan sub-assembly.

    1. Collect any steel chips using the removed oil cleaner magnets.
      Carefully inspect the foreign matter and particles in the automatic transaxle oil pan sub-assembly and on the oil cleaner magnets to guess at the type of wear which might be found in the automatic transaxle.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bearing wear



5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


C203892
  1. Remove the 3 bolts and the valve body oil strainer assembly.

    NOTICE:
    Perform the operation carefully as some fluid will come out from the valve body oil strainer assembly.



    C057509E01
  1. Remove the oil strainer gasket from the valve body oil strainer assembly.



6. SEPARATE TRANSMISSION WIRE


    C203893
  1. Disconnect the 5 connectors from the transmission valve body assembly.

  1. Disengage the clamp and separate the transmission wire.



7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    C203894
  1. Remove the 14 bolts.



    C057516E02
  1. Disconnect the manual valve control rod from the manual valve lever, then remove the transmission valve body assembly.



    C059784E01
  1. Remove the No. 1 governor apply gasket.