Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > DISASSEMBLY

for Preparation Click here



1. REMOVE UPPER POSITION INDICATOR HOUSING


C244564
  1. Disengage the 4 claws and remove the upper position indicator housing from the shift lock control unit assembly.



2. REMOVE CONTROL POSITION INDICATOR PLATE


C244629
  1. Disengage the claw and remove the control position indicator plate from the upper position indicator housing.



3. REMOVE SHIFT LOCK CONTROL ECU SUB-ASSEMBLY


    C244571
  1. Disengage the claw and pull out the shift lock control ECU sub-assembly from the shift lock control unit assembly.



    C244572
  1. Disengage the 3 clamps and separate the shift lock solenoid wire from the shift lock unit cover.

  1. Disconnect the shift lock solenoid connector.



    C235343
  1. Disengage the 3 claws and remove the shift lock unit cover from the shift lock control ECU sub-assembly.



4. REMOVE POSITION INDICATOR SLIDE COVER


C241911
  1. Remove the position indicator slide cover from the shift lock control unit assembly.



5. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER


C235350
  1. Align the cutouts on the shank of the No. 2 position indicator slide cover and the position indicator slide cover, and remove the No. 2 position indicator slide cover from the position indicator slide cover.



6. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY


C244569
  1. Separate the indicator light wire socket.



    C244570
  1. Disengage the 4 clamps and separate the indicator light wire sub-assembly from the shift lock control unit assembly.



    C236989
  1. Using a screwdriver, lift up the terminal retainer of the transmission control switch connector to release the lock.



    C155838E02
  1. Using a thin-bladed screwdriver, pull out terminal 7 and 14 of the transmission control switch connector.
    Text in Illustration 
    *a
    Component without harness connected
    (Transmission Control Switch)



7. REMOVE POSITION INDICATOR LIGHT BULB
  1. Remove the position indicator light bulb from the indicator light wire sub-assembly.



8. REMOVE POSITION INDICATOR LIGHT CAP
  1. Remove the position indicator light cap from the position indicator light bulb.



9. REMOVE LOWER POSITION INDICATOR HOUSING


    C244573
  1. Disengage the 4 claws and remove the lower position indicator housing from the shift lock control unit assembly.