SHIFT LEVER > DISASSEMBLY |
| 1. REMOVE UPPER POSITION INDICATOR HOUSING |
![]() |
Disengage the 4 claws and remove the upper position indicator housing from the shift lock control unit assembly.
| 2. REMOVE CONTROL POSITION INDICATOR PLATE |
![]() |
Disengage the claw and remove the control position indicator plate from the upper position indicator housing.
| 3. REMOVE SHIFT LOCK CONTROL ECU SUB-ASSEMBLY |
![]() |
Disengage the claw and pull out the shift lock control ECU sub-assembly from the shift lock control unit assembly.
![]() |
Disengage the 3 clamps and separate the shift lock solenoid wire from the shift lock unit cover.
Disconnect the shift lock solenoid connector.
![]() |
Disengage the 3 claws and remove the shift lock unit cover from the shift lock control ECU sub-assembly.
| 4. REMOVE POSITION INDICATOR SLIDE COVER |
![]() |
Remove the position indicator slide cover from the shift lock control unit assembly.
| 5. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER |
![]() |
Align the cutouts on the shank of the No. 2 position indicator slide cover and the position indicator slide cover, and remove the No. 2 position indicator slide cover from the position indicator slide cover.
| 6. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY |
![]() |
Separate the indicator light wire socket.
![]() |
Disengage the 4 clamps and separate the indicator light wire sub-assembly from the shift lock control unit assembly.
![]() |
Using a screwdriver, lift up the terminal retainer of the transmission control switch connector to release the lock.
![]() |
Using a thin-bladed screwdriver, pull out terminal 7 and 14 of the transmission control switch connector.
| *a | Component without harness connected (Transmission Control Switch) |
| 7. REMOVE POSITION INDICATOR LIGHT BULB |
Remove the position indicator light bulb from the indicator light wire sub-assembly.
| 8. REMOVE POSITION INDICATOR LIGHT CAP |
Remove the position indicator light cap from the position indicator light bulb.
| 9. REMOVE LOWER POSITION INDICATOR HOUSING |
![]() |
Disengage the 4 claws and remove the lower position indicator housing from the shift lock control unit assembly.