Home › Drivetrain ยท U441E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > REASSEMBLY

for Preparation Click here



1. INSTALL LOWER POSITION INDICATOR HOUSING


    C244575
  1. Engage the 4 claws and install the lower position indicator housing to the shift lock control unit assembly.



2. INSTALL POSITION INDICATOR LIGHT CAP
  1. Install the position indicator light cap to the position indicator light bulb.



3. INSTALL POSITION INDICATOR LIGHT BULB
  1. Install the position indicator light bulb to the indicator light wire sub-assembly.



4. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY


    C155838E02
  1. Install the indicator light wire sub-assembly to terminals 7 and 14 of the transmission control switch connector.
    Text in Illustration 
    *a
    Component without harness connected
    (Transmission Control Switch)



    C236990
  1. Push down the terminal retainer of the transmission control switch connector to lock it.



    C244570
  1. Engage the 4 clamps and install the indicator light wire sub-assembly to the shift lock control unit assembly.



    C244593
  1. Install the indicator light wire socket.



5. INSTALL NO. 2 POSITION INDICATOR SLIDE COVER


    C235350
  1. Align the cutouts on the shank of the No. 2 position indicator slide cover and the position indicator slide cover, and install the No. 2 position indicator slide cover to the position indicator slide cover.



6. INSTALL POSITION INDICATOR SLIDE COVER


    C241911E02
  1. Install the position indicator slide cover to the shift lock control unit assembly.
    Text in Illustration 
    *a
    Front of Vehicle
    *b
    Arrow

    NOTICE:
    Install the position indicator slide cover do that its arrow mark points to the front of the vehicle.



7. INSTALL SHIFT LOCK CONTROL ECU SUB-ASSEMBLY


    C235343
  1. Engage the 3 claws and install the shift lock unit cover to the shift lock control ECU sub-assembly.



    C244572
  1. Connect the shift lock solenoid connector.

  1. Engage the 3 clamps and install the shift lock solenoid wire to the shift lock unit cover.



    C244571
  1. Engage the claw and install the shift lock control ECU sub-assembly to the shift lock control unit assembly.



8. INSTALL CONTROL POSITION INDICATOR PLATE


    C244629
  1. Engage the claw and install the control position indicator plate to the upper position indicator housing.



9. INSTALL UPPER POSITION INDICATOR HOUSING


    C244564
  1. Engage the 4 claws and install the upper position indicator housing to the shift lock control unit assembly.

    NOTICE:
    Securely engage the 4 claws.