TORQUE CONVERTER AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER ASSEMBLY |
Inspect the one-way clutch.
![]() |
Press on the splines of the stator with a finger and rotate it. Check that it rotates smoothly when turned clockwise and rotates with difficulty when turned counterclockwise.
![]() | Difficult |
![]() | Smooth |
![]() |
Inspect the torque converter assembly.
If any of the following problems are present, replace the torque converter assembly.
| *a | Sample showing maximum allowable amount of powder in ATF |
Replace the ATF in the torque converter assembly.
If the ATF is discolored or has a foul odor, stir the ATF in the torque converter assembly before replacing the ATF.
Clean and check the oil cooler and oil pipe line.
![]() |
![]() |
Prevent deformation of the torque converter assembly and damage to the oil pump gear.
| *a | Correct |
| *b | Incorrect |
| *c | Bottom is damaged |
| 2. INSPECT DRIVE PLATE AND RING GEAR |
![]() |
Check the drive plate damage.
![]() | Measurement Point |
Using a dial indicator with a roller instrument, measure the runout at the 6 areas on the drive plate surface that contact the torque converter assembly.