AUTOMATIC TRANSAXLE UNIT > INSPECTION |
| 1. INSPECT DIRECT CLUTCH DISC |
![]() |
Check whether the sliding surface of the direct clutch disc, rear clutch flange and direct clutch flange are worn or burnt.
| 2. INSPECT 1ST AND REVERSE BRAKE DISC |
![]() |
Check to see if the sliding surface of the 1st and reverse brake disc, 1st and reverse brake plate and 1st and reverse brake flange are worn or burnt.
| 3. INSPECT 2ND BRAKE BRAKE DISC |
![]() |
Check whether the sliding surfaces of the 2nd brake brake disc, No. 1 2nd brake brake flange and 2nd brake brake flange are worn or burnt.
| 4. INSPECT 2ND COAST AND OVERDRIVE BRAKE DISC |
![]() |
Check whether the sliding surfaces of the 2nd coast and overdrive brake disc, No. 2 2nd coast and overdrive brake flange and 2nd coast and overdrive brake flange are worn or burnt.
| 5. INSPECT FRONT CLUTCH CLUTCH DISC |
![]() |
Check whether the sliding surface of the front clutch clutch disc, No. 1 clutch plate and forward clutch flange are worn or burnt.
| 6. INSPECT REVERSE CLUTCH DISC |
![]() |
Check whether the sliding surfaces of the reverse clutch disc, No. 3 clutch plate and reverse clutch flange are worn or burnt.
| 7. INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
| 8. INSPECT 1ST AND REVERSE BRAKE RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
| 9. INSPECT 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
| 10. INSPECT OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
| 11. INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
| 12. INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY |
![]() |
Shake the direct clutch pin and confirm that the check ball is not stuck.
Apply low pressure compressed air to the check ball and check that no air leakage is identified.
If necessary, replace the direct clutch piston sub-assembly.
| 13. INSPECT INTERMEDIATE SHAFT SUB-ASSEMBLY |
![]() |
Shake the direct clutch pin and confirm that the check ball is not stuck.
Apply low pressure compressed air to the check ball and check that no air leakage is identified.
If necessary, replace the intermediate shaft sub-assembly.