OIL PUMP > REASSEMBLY |
| 1. INSTALL CLUTCH DRUM OIL SEAL RING |
![]() |
Coat 2 new clutch drum oil seal rings with Toyota Genuine ATF WS, and install them to the stator shaft assembly.
| 2. INSTALL FRONT OIL PUMP OIL SEAL |
![]() |
Coat a new front oil pump oil seal lip with MP grease.
Using SST and a hammer, install the front oil pump oil seal to the front oil pump body.
| 3. INSTALL FRONT OIL PUMP DRIVEN GEAR |
![]() |
Coat the front oil pump driven gear with Toyota Genuine ATF WS, and install it to the front oil pump body with the marked side facing upward.
| *a | Mark |
| 4. INSTALL FRONT OIL PUMP DRIVE GEAR |
![]() |
Coat the front oil pump drive gear with Toyota Genuine ATF WS, and install it to the front oil pump body with the marked side facing upward.
| *a | Mark |
| 5. INSTALL STATOR SHAFT ASSEMBLY |
![]() |
Using "TORX" socket wrench T30, install the stator shaft assembly with 10 "TORX" screws.
| 6. INSPECT OIL PUMP ASSEMBLY |
![]() |
Turn the front oil pump drive gear with 2 screwdrivers and make sure it rotates smoothly.
| 7. INSTALL FRONT OIL PUMP BODY O-RING |
![]() |
Coat a new front oil pump body O-ring with Toyota Genuine ATF WS, and install it to the front oil pump body.