INPUT SHAFT > DISASSEMBLY |
| 1. INSPECT 4TH GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the 4th gear thrust clearance.
| 2. INSPECT 3RD GEAR THRUST CLEARANCE |
![]() |
Using a dial indicator, measure the 3rd gear thrust clearance.
| 3. INSPECT 4TH GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the 4th gear radial clearance between the 4th gear and input shaft.
| 4. INSPECT 3RD GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the 3rd gear radial clearance between the 3rd gear and input shaft.
| 5. REMOVE 4TH GEAR |
![]() |
Using 2 screwdrivers and a hammer, remove the input shaft rear bearing shaft snap ring from the input shaft.
![]() |
Using SST and a press, remove the input shaft rear radial ball bearing and the 4th gear from the input shaft.
| 6. REMOVE 4TH GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 4th gear needle roller bearing and the 4th gear bearing spacer from the input shaft.
| 7. REMOVE 4TH GEAR SYNCHRONIZER RING |
![]() |
Remove the 4th gear synchronizer ring from the No. 2 transmission clutch hub.
| 8. REMOVE 3RD GEAR |
![]() |
Using 2 screwdrivers and a hammer, remove the snap ring from the input shaft.
![]() |
Using SST and a press, remove the No. 2 transmission clutch hub and the 3rd gear from the input shaft.
| 9. REMOVE 3RD GEAR SYNCHRONIZER RING |
![]() |
Remove the 3rd gear synchronizer ring from the 3rd gear.
| 10. REMOVE 3RD GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 3rd gear needle roller bearing from the input shaft.
| 11. REMOVE NO. 2 TRANSMISSION HUB SLEEVE |
![]() |
Remove the No. 2 transmission hub sleeve, the 3 synchromesh shifting keys and the 3 synchromesh shifting key springs from the No. 2 transmission clutch hub.