Home › Drivetrain ยท C54 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > INSPECTION

for Preparation Click here



1. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER


C068517
  1. Using a micrometer, measure the thickness of the front differential pinion thrust washer.

    Minimum thickness:
    0.94 mm (0.0370 in.)

    If the thickness is less than the minimum, replace the front differential pinion thrust washer.



2. INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT


C068518
  1. Using a micrometer, measure the outer diameter of front No. 1 differential pinion shaft.

    Minimum outer diameter:
    16.982 mm (0.669 in.)

    If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.