Home › Drivetrain ยท C54 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > DISASSEMBLY

for Preparation Click here



1. REMOVE SPEEDOMETER DRIVE GEAR


C067982E04
  1. Remove the speedometer drive gear from the front differential case.



2. REMOVE FRONT DIFFERENTIAL RING GEAR


    D032380E07
  1. Place matchmarks on the front differential ring gear and the front differential case.
    Text in Illustration 
    *a
    Matchmark

  1. Remove the 8 bolts.



    C067984
  1. Using a plastic hammer, remove the front differential ring gear from the front differential case.



3. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH


C067989
  1. Fix the front differential pinion to the front differential case side. Using a dial indicator, measure the front differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.00197 to 0.00787 in.)

    If the backlash is outside the specifications, replace the front No. 1 differential side gear thrust washers.



4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


C193758E01
  1. Using SST and a hammer, loosen the staked part of the front differential case.

    SST
    09930-00010  



    C067986
  1. Using a pin punch (3 mm) and a hammer, remove the front differential pinion shaft straight pin from the front differential case.



5. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT


C067987
  1. Remove the front No. 1 differential pinion shaft from the front differential case.



6. REMOVE FRONT DIFFERENTIAL SIDE GEAR


C067988
  1. Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front No. 1 differential side gear thrust washers and the 2 front differential side gears from the front differential case.

    HINT:
    Revolving the front differential pinion, remove the 2 front differential pinions and 2 front differential side gears.