Home › Drivetrain ยท C54 MANUAL TRANSMISSION / TRANSAXLE › SHIFT AND SELECT LEVER SHAFT

SHIFT AND SELECT LEVER SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 SELECT SPRING SEAT


C120733
  1. Using a screwdriver, remove the E-ring, No. 2 select spring seat and the compression spring from the shift and select lever shaft.



2. REMOVE NO. 2 SHIFT LEVER INNER


C120734
  1. Using a pin punch (5 mm) and a hammer, remove the slotted spring pin and the No. 2 shift lever inner from the shift and select lever shaft.

    HINT:
    Check the orientation of the No. 2 shift lever inner.



3. REMOVE NO. 1 SHIFT LEVER INNER


C121093
  1. Using a pin punch (5 mm) and a hammer, remove the slotted spring pin, No. 1 shift lever inner and the shift inter lock plate from the shift and select lever shaft.

    HINT:
    Check the orientation of the No. 1 shift lever inner.



4. REMOVE SELECT INNER LEVER


C120736
  1. Using a pin punch (5 mm) and a hammer, remove the slotted spring pin, select inner lever, compression spring and the No. 1 select spring seat from the shift and select lever shaft.

    HINT:
    Check the orientation of the select inner lever.



5. REMOVE SELECT SPRING NO. 1 SEAT SHAFT SNAP RING


C120737
  1. Using 2 screwdrivers and a hammer, remove the select spring No. 1 seat shaft snap ring.