Home › Drivetrain ยท C54 MANUAL TRANSMISSION / TRANSAXLE › SHIFT AND SELECT LEVER SHAFT

SHIFT AND SELECT LEVER SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL SELECT SPRING NO. 1 SEAT SHAFT SNAP RING
  1. Coat the shift and select lever shaft with MP grease.



    C120738
  1. Install the select spring No. 1 seat shaft snap ring to the shift and select lever shaft using a brass bar and a hammer.



2. INSTALL SELECT INNER LEVER


C163847
  1. Coat the No. 1 select spring seat with MP grease.

  1. Using a pin punch (5 mm) and a hammer, install the No. 1 select spring seat, compression spring, select inner lever and the slotted spring pin onto the shift and select lever shaft.

    Standard drive in depth:
    3.0 to 4.0 mm (0.118 to 0.157 in)

    NOTICE:
    Do not install the No. 1 select spring seat in the wrong direction.



3. INSTALL NO. 1 SHIFT LEVER INNER


C163848
  1. Coat the shift inter lock plate and No. 1 shift lever inner with MP grease.

  1. Using a pin punch (5 mm) and a hammer, install the shift inter lock plate, No. 1 shift lever inner and the slotted spring pin onto the shift and select lever shaft.

    Standard drive in depth:
    -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)



4. INSTALL NO. 2 SHIFT LEVER INNER


C170508
  1. Coat the No. 2 shift lever inner with MP grease.

  1. Using a pin punch (5 mm) and a hammer, install the No. 2 shift lever inner and the slotted spring pin onto the shift and select lever shaft.

    Standard drive in depth:
    1.0 to 2.0 mm (0.0394 to 0.0787 in.)



5. INSTALL NO. 2 SELECT SPRING SEAT


C120739
  1. Coat the No. 2 select spring seat with MP grease.

  1. Install the No. 2 select spring seat and the compression spring. Using pliers, install a new E-ring onto the shift and select lever shaft.