Home › Drivetrain ยท C54 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE UNIT

MANUAL TRANSAXLE UNIT > INSPECTION

for Preparation Click here



1. INSPECT NO. 3 SYNCHRONIZER RING


C067848
  1. Check for wear and damage.

  1. Coat the 5th gear cone with gear oil.

  1. Turn the No. 3 synchronizer ring in one direction while pushing it against the 5th gear cone.

  1. Check that the ring locks.
    If the No. 3 synchronizer ring does not lock, replace the No. 3 synchronizer ring.



    C067850
  1. Using a feeler gauge, measure the clearance between the No. 3 synchronizer ring back and the gear spline end.

    Minimum clearance:
    0.75 mm (0.0295 in.)

    If the clearance is less than the minimum, replace the No. 3 synchronizer ring.



2. INSPECT NO. 3 TRANSMISSION HUB SLEEVE


C067978
  1. Check the sliding condition between the No. 3 transmission hub sleeve and the No. 3 transmission clutch hub.

  1. Check that the edges of the No. 3 transmission hub sleeve spline gear are not worn down.



    C080375E08
  1. Using a vernier caliper, measure the width of the No. 3 transmission hub sleeve groove (A) and the thickness of the claw part on the No. 3 gear shift fork (B), and calculate the clearance.
    Text in Illustration 
    *a
    Clearance = (A - B)

    Standard clearance (A - B):
    0.3 to 0.5 mm (0.0118 to 0.00197 in.)

    If the clearance exceeds the standard, replace the No. 3 transmission hub sleeve and the No. 3 gear shift fork.



3. INSPECT 5TH GEAR


C067975
  1. Using a caliper gauge, measure the inside diameter of the 5th gear.

    Standard inside diameter:
    29.915 to 29.931 mm (1.1778 to 1.1784 in.)

    Maximum inside diameter:
    29.931 mm (1.1784 in.)

    If the inside diameter exceeds the maximum, replace the 5th gear.



4. INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY


C067846E01
  1. Using a caliper gauge, inspect the reverse idle gear sub-assembly.

    Standard inside diameter:
    18.040 to 18.058 mm (0.710 to 0.711 in.)

    Maximum inside diameter:
    18.058 mm (0.711 in.)

    If the inside diameter exceeds the maximum, replace the reverse idler gear sub-assembly.

  1. Using a micrometer, inspect the reverse idler gear shaft as shown in the illustration.

    Standard outer diameter:
    17.966 to 17.984 mm (0.707 to 0.708 in.)

    Minimum outer diameter:
    17.966 mm (0.707 in.)

    If the outer diameter is less than the minimum, replace the reverse idler gear shaft.