Home › Audio/Visual/Telematics › AUDIO / VIDEO › QUARTER TRIM SPEAKER

QUARTER TRIM SPEAKER > INSPECTION

for Preparation Click here



1. INSPECT REAR SPEAKER ASSEMBLY
  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.



    E122035E01
  1. Check the speaker resistance.
    Text in Illustration  
    *a
    Component without harness connected
    (Rear Speaker Assembly)

    1. Disconnect the rear speaker assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      Approximately 4 Ω

      If the result is not as specified, replace the rear speaker assembly.