FRONT SHOCK ABSORBER > INSTALLATION |
| 1. INSTALL STRUT MOUNTING BEARING |
![]() |
Using a brass bar and press, install the strut mounting bearing onto the front coil spring upper seat.
| 2. INSTALL FRONT COIL SPRING |
![]() |
Using SST, compress the front coil spring.
| *a | Lower End |
Install the front coil spring onto the front shock absorber.
| 3. INSTALL FRONT COIL SPRING UPPER INSULATOR |
| 4. INSTALL FRONT SPRING BUMPER |
![]() |
Install the front spring bumper onto the front coil spring upper seat with the air discharge groove of the front spring bumper and the rib portion of the front coil spring upper seat aligned.
| *a | Rib Portion |
| *b | Air Discharge Groove |
| 5. INSTALL FRONT COIL SPRING UPPER SEAT |
Install the front coil spring upper seat with the strut mounting bearing and front spring bumper onto the front shock absorber.
Provisionally tighten a new nut.
Remove SST from the front coil spring.
![]() |
Using SST and socket hexagon wrench 6, fix the shock absorber rod and tighten the nut.
| *1 | Long Socket Hexagon Wrench 6 |
| 6. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY |
| 7. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() |
Provisionally tighten a new nut through the front No. 2 suspension support.
Install the front shock absorber with coil spring onto the steering knuckle.
Install the 2 bolts and 2 nuts.
| 8. INSTALL FRONT FLEXIBLE HOSE (w/ ABS) |
Install the front flexible hose and front speed sensor with the bolt.
| 9. INSTALL FRONT FLEXIBLE HOSE (w/o ABS) |
Install the front flexible hose with the bolt.
| 10. INSTALL FRONT STABILIZER LINK ASSEMBLY |
Install the front stabilizer link assembly with the nut.
| 11. INSTALL FRONT WHEEL |
| 12. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() |
Using SST and socket hexagon wrench 6, fix the front shock absorber rod and tighten the nut.
| *a | Hold |
| *b | Turn |
| 13. INSTALL FRONT SUSPENSION SUPPORT DUST COVER |
| 14. INSTALL OUTER COWL TOP PANEL |
Install the outer cowl top panel with the 8 bolts.
Engage the 2 clamps and install the wire harness.
| 15. INSTALL INNER COWL TOP TO COWL BRACE |
Install the cowl top to cowl brace with the 2 bolts.
| 16. INSTALL FRONT NO. 1 VENTILATOR SEAL |
Engage the clip and install the front No. 1 ventilator seal.
| 17. INSTALL FRONT AIR SHUTTER SEAL RH |
| 18. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY |
| 19. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |