POWER STEERING SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / EMPS / DTC.
Read the DTCs following the display on the tester.
Refer to Diagnostic Trouble Code Chart for DTC information (Click here).
| CLEAR DTC |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the tester on.
Enter the following menus: Chassis / EMPS / DTC.
Clear the DTCs by following the display on the tester.
Turn the ignition switch off.
Disconnect the intelligent tester from the DLC3.