Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO. 1 STABILIZER BAR BUSH


    C233390E01
  1. Install the front No. 1 stabilizer bar bush onto the front stabilizer bar.
    Text in Illustration 
    *1
    Bush Stopper
    V100135
    Front Side
    V100136
    Outer Side

    HINT:
    1. Install the front No. 1 stabilizer bar bush onto the front stabilizer bar so that the bush stopper of the front stabilizer bar faces the outside of the vehicle.
    2. Install the front No. 1 stabilizer bar bush with its cutout facing the front of the vehicle.



2. INSTALL FRONT STABILIZER BAR


    C233662E01
  1. Install the front stabilizer bar onto the front suspension crossmember sub-assembly with the paint mark on the left side of the vehicle.
    Text in Illustration 
    *a
    Paint Mark
    V100135
    Left Side



3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH


    C229644E01
  1. Provisionally tighten bolt A.

  1. Tighten the bolts to the specified torque, in the order of B then A.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }



4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:
Use the same procedure for the RH side as for the LH side.



5. INSTALL MANUAL STEERING GEAR
  1. Install the manual steering gear onto the front suspension crossmember with the 2 bolts and 2 nuts.

    Torque:
    96 N*m{ 979 kgf*cm , 71 ft.*lbf }

    NOTICE:
    Keep the nut from rotating while turning the bolt.



6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
  1. Install the front stabilizer link assembly with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    Using a socket hexagon wrench 6 to hold the stud.



7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure for the RH side as for the LH side.



8. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
(Click here)