REAR COIL SPRING > REMOVAL |
| 1. REMOVE REAR WHEEL |
| 2. DRAIN BRAKE FLUID |
| 3. SEPARATE SKID CONTROL SENSOR WIRE LH (w/ ABS) |
![]() |
Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire LH connector.
![]() |
Remove the nut and separate the skid control sensor wire LH.
| 4. SEPARATE SKID CONTROL SENSOR WIRE RH (w/ ABS) |
| 5. SEPARATE REAR FLEXIBLE HOSE LH |
![]() |
Using a union nut wrench (10 mm), separate the brake tube while holding the rear flexible hose LH with a wrench.
Remove the clip and disconnect the rear flexible hose LH from the rear axle beam assembly.
| 6. SEPARATE REAR FLEXIBLE HOSE RH |
| 7. LOOSEN REAR AXLE BEAM ASSEMBLY |
![]() |
Loosen the 2 bolts.
| *a | RH Side |
| *b | LH Side |
| 8. SEPARATE REAR SHOCK ABSORBER ASSEMBLY LH |
![]() |
Support the rear axle beam assembly using a jack and wooden block as shown in the illustration.
Remove the bolt while keeping the nut from rotating and separate the rear shock absorber assembly LH.
| 9. SEPARATE REAR SHOCK ABSORBER ASSEMBLY RH |
| 10. REMOVE REAR COIL SPRING LH |
Lower the jack slowly.
Remove the rear coil spring LH, rear coil spring upper insulator LH and rear coil spring lower insulator LH.
| 11. REMOVE REAR COIL SPRING RH |