CLUTCH PEDAL (for LHD) > INSTALLATION |
| 1. INSTALL CLUTCH PEDAL PAD |
Install the clutch pedal pad to the clutch pedal sub-assembly.
| 2. INSTALL NO. 1 CLUTCH PEDAL CUSHION |
Install the No. 1 clutch pedal cushion to the clutch pedal sub-assembly.
| 3. INSTALL CLUTCH PEDAL SHAFT COLLAR |
![]() |
Apply MP grease to both sides of 2 new clutch pedal bushes.
![]() | MP grease |
Install the 2 clutch pedal bushes and the clutch pedal shaft collar to the clutch pedal sub-assembly.
| 4. INSTALL CLUTCH PEDAL SUB-ASSEMBLY |
Install the clutch pedal sub-assembly to the clutch pedal support sub-assembly with the bolt and the nut.
| 5. INSTALL CLUTCH PEDAL SPRING |
Install the clutch pedal spring to the clutch pedal sub-assembly and the clutch pedal support sub-assembly.
| 6. INSTALL CLUTCH PEDAL STOPPER BOLT |
Install the clutch pedal stopper bolt to the clutch pedal support sub-assembly and temporarily tighten the lock nut.
| 7. INSTALL CLUTCH START SWITCH ASSEMBLY |
Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.
| 8. INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY |
![]() |
Apply MP grease to the contact surface of the clutch master cylinder push rod clevis and the clutch pedal sub-assembly.
![]() | MP grease |
Install the clutch master cylinder push rod clevis to the cutout of the clutch pedal sub-assembly from the left side of the vehicle and push it downward.
Install the clutch pedal support sub-assembly to the vehicle with the bolt and the 2 nuts.
Connect the connector and engage the wire harness clamp.
![]() |
With the clutch pedal fully depressed, check that the clearance shown in the illustration is as specified.
| *a | Clearance |
![]() | Fully depressed |
| 9. INSPECT AND ADJUST CLUTCH PEDAL |
| 10. INSTALL COMBINATION METER ASSEMBLY |
| 11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL |
for LHD:
Engage the 5 claws and 2 clips and install the instrument panel finish panel.
for RHD:
Engage the 6 claws and 2 clips and install the instrument panel finish panel.
| 12. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL |
Engage the 2 claws and 5 clips and install the instrument panel finish panel.
| 13. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Engage the guide and the claw.
Install the instrument panel under cover with the 2 <A> screws.
| 14. INSPECT CLUTCH START SYSTEM |
Check that the engine does not start when the clutch pedal is released.
Check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch assembly.