Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR

REAR SPEED SENSOR > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.



    C233134E01
  1. Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
    Text in Illustration 
    *1
    Automatic Adjust Lever
    V100135
    Contract

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.



3. DISCONNECT SKID CONTROL SENSOR WIRE


C107565
  1. Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire connector.



4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    C236427
  1. Remove the 4 bolts and remove the rear axle hub and bearing assembly from the axle beam.

    NOTICE:
    Suspend the backing plate with a piece of rope.

    HINT:
    The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.