Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE

PARKING BRAKE CABLE > REMOVAL

for Preparation Click here



1. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


2. LOOSEN PARKING BRAKE CABLE


C234723E03
  1. Loosen the equalizer and lock nut.
    Text in Illustration 
    *1
    Parking Brake Equalizer
    *2
    Lock Nut

    NOTICE:
    Do not reuse the loosened nut.



3. REMOVE REAR WHEEL


4. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.



    C233134E01
  1. Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
    Text in Illustration 
    *1
    Automatic Adjust Lever
    V100135
    Contract

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.



5. REMOVE REAR BRAKE SHOE KIT


    C108968E01
  1. Using SST, separate the shoe return spring from the front brake shoe.

    SST
    09921-00011  

    NOTICE:
    Do not damage the wheel cylinder boot.



    C108969E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.

    SST
    09718-00011  

  1. Remove the tension spring.



    C108970
  1. Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.



    C108971E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.

    SST
    09718-00011  



    C108972
  1. Using needle-nose pliers, separate the parking brake cable.



6. REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR


    A247502
  1. Remove the 2 nuts and the front No. 2 floor heat insulator.



7. REMOVE FUEL TANK COVER VENT CASE SUB-ASSEMBLY


    A247503
  1. Remove the clip.

  1. Remove the bolt and fuel tank cover vent case sub-assembly.



8. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C235481E01
  1. Separate the No. 3 parking brake cable assembly from the parking brake equalizer.
    Text in Illustration 
    *1
    Parking Brake Equalizer
    *2
    No. 2 parking brake cable assembly
    *3
    No. 3 parking brake cable assembly



  1. Remove cable clamp A from the body.


    C235067E01

  1. Remove the 5 bolts.

  1. Remove the cable clamp B from the rear axle beam.



    C109000
  1. Remove the bolt and No. 3 parking brake cable assembly from the backing plate.



9. REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY

HINT:
Use the same procedure for the RH side as for the LH side.