PARKING BRAKE SWITCH > INSPECTION |
| 1. INSPECT PARKING BRAKE SWITCH ASSEMBLY |
![]() |
Measure the resistance between the connector terminal and the nut inside the parking brake switch assembly.
| *a | Component without harness connected (Parking Brake Switch Assembly) |
![]() | ON |
![]() | OFF |
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Switch body | Parking brake switch ON (Switch pin free) | Below 1 Ω |
| Parking brake switch OFF (Switch pin pushed in) | 10 kΩ or higher |